AmeTex Roofing

1- tear off, and leave on site roof panels 2-install 24 gauge Class 4 impact resistant Muller MLK 2 standing seam 16 wide galvalum interlocking seamed roof 3- remove and replace floating interlocking clips 4- remove and replace 99 LF of rake plates inc butyl tape 5- remove and replace 99 LF of end wall flashing 6- remove and replaced 96 LF of Z bar, inc butyl tape 7- remove and replace 96 LF of eave plates 8- remove and replace 450 sq ft of insulation 9- remove and replace 294 sq ft of parapet wall panels 10- replace gutters and dowspouts

1- tear off, haul and dispose 2 layer of composition shingles & 1 Layer of Wooden shingles 2- Install 7/16" OSB to roof structure and install new roof support as needed . Along with Fascia Repairs to allow proper drip edge installation 3- install synthetic felt with 1'' plastic cap nails 4- laminated composition shingles weatherwood 5- standard profile ridge cap weatherwood 6- remove drip edge, install 2''x2'' pre-painted weatherwood drip edge 7- ice-water shield moisture barrier on valleys 8- remove and replace pipe jacks and paint to match shingles 9- remove and replace roof vents; install pre-painted roof vents to match shingles 10- complete clan up, magnet sweep yard and haul away all trash and debris collected from project

1- tear off one layer of composition shingles 2- install synthetic felt with 1'' plastic cap nails 3- laminated composition shingles weatherwood 4- standard profile ridge cap weatherwood 5- remove drip edge, install 2''x2'' pre-painted weatherwood drip edge 6- ice-water shield moisture barrier on valleys 7- remove and replace pipe jacks and paint to match shingles. 1-3",3-1.5'' 8- remove and replace 10 turtle roof vents; install pre-painted roof vents to match shingles 9- city of waco permit and inspection 10- complete clan up, magnet sweep yard and haul and dispose of all trash and debris collected from project 11- repair 2 sheets of decking on rear slope 5 years limited labor warranty

1- tear off one layer of composition shingles 2- install synthetic felt with 1'' plastic cap nails 3- laminated composition shingles weatherwood 4- standard profile ridge cap weatherwood 5- remove drip edge, install 2''x2'' pre-painted weatherwood drip edge 6- ice-water shield moisture barrier on valleys 7- remove and replace pipe jacks and paint to match shingles. 1-4",1-1.5" 8- add 5 turtle back roof vents; install pre-painted roof vents to match shingles 9- install self adhesive modified bitumen of rear low slope roof 10- reflash both chimneys 11- city of waco permit and inspection 12- complete clan up, magnet sweep yard and haul and dispose of all trash and debris collected from project

1- tear off one layer of composition shingles 2- Owens corning starter 3- Owens Corning Rhino synthetic felt 4- Owens Corning Oakridge laminated composition shingles Driftwood 5- Owens Corning Ice-water shield moisture barriers on alleys 6- Owens Corning standard profile ridge cap from 3 tab supreme Driftwood 7- Owens corning ridge vent 8- remove all plumbing pipe jacks, replace with leads and paint to match shingles 9- magnet sweep yard, complete clean up, haul and dispose of trash and debris collected from project